Standard RNA Synthesis (E2050)

Abstract

This is the synthesis protocol using the HiScribe™ T7 Quick High Yield RNA Synthesis Kit (E2050)

Before start

We strongly recommend wearing gloves and using nuclease-free tubes and reagents to avoid RNase contamination. Reactions are typically 20µL but can be scaled up as needed. Reactions should be assembled in nuclease-free microfuge tubes or PCR strip tubes.

Steps

Thaw the necessary kit components.

Mix and pulse-spin in microfuge to collect solutions to the bottoms of tubes. Keep On ice.

Assemble the reaction at Room temperature in the following order:

A	B
Nuclease-free water	X µl
NTP Buffer Mix	10 µl (10 mM each NTP final)
Template DNA	X µl (1 µg)
T7 RNA Polymerase Mix	2 µl
Total reaction volume	20 µl

Mix thoroughly and pulse-spin in a microfuge.

Incubate at 37°C for 2h 0m 0s.

Note

Reaction time depends on template amount, quality and RNA transcript length. For reactions with transcripts longer than 0.3 kb, 2 hour incubation should give you the maximum yield. For reaction times of 60 minutes or less, a water bath or heating block may be used; for reaction times longer than 60 minutes, we recommend using a dry air incubator or a thermocycler to prevent evaporation of the sample.For reactions with short RNA transcripts (< 0.3 kb), we recommend an incubation time of 4 hours or longer. It is safe to incubate the reaction for 16 hours (overnight). For example, we have achieved good yield with only 0.2 μg plasmid template encoding a 50-mer RNA by incubating the reaction overnight at 37°C.Reaction set up for short transcripts (< 0.3 kb): Nuclease-free water X µlNTP Buffer Mix10 µl (6.7 mM each NTP final)Template DNAX µl (1 µg)T7 RNA Polymerase Mix2 µlTotal reaction volume30 µl Compared to the standard reaction, this reaction uses 10 μl more water. The volume of NTP Buffer Mix and T7 RNA Polymerase Mix, however, remains the same. The kit contains sufficient materials for 50 reactions.Note that the amount of NTP Buffer Mix in a standard 20 μl reaction can vary from 2 to 10 μl. The final yield is proportional to the amount of input nucleotides, meaning that the nucleotide incorporation efficiency remains the same when different amounts of NTP are used. Figure 1 shows the time course of standard RNA synthesis from 1 μg control DNA template coding for a 1.8 kb RNA transcript with the HiScribe T7 Quick Kit using 10 μl and 5 μl NTP Buffer Mix in a 20 μl reaction.

Citation

Figure 1. RNA synthesis with different amounts of NTP.Reactions were incubated at 37°C in a thermocycler. Transcripts were purified by spin columns and quantified on a NanoDrop™ Spectrophotometer.

Optional step : To remove template DNA, add 30µL to each 20 μl reaction, followed by 2µL, mix and incubate at 37°C for 0h 15m 0s.

Note

Standard reactions are capable of generating large amounts of RNA, at concentrations up to 10 mg/ml. As a result, the reaction mixture is quite viscous. It is easier to perform DNase treatment after the reaction mixture is diluted.

Proceed with purification of synthesized RNA (we recommend the Monarch RNA Cleanup Kits, NEB #T2040 or #T2050) or analysis of transcription products by gel electrophoresis.

Abstract

Before start

Steps

推荐阅读