Transfer of plasmid DNA to Rhodobacter  sphaeroides via Conjugal mating

Two days prior to the conjugation, inoculate 25 ml of ^GYCC with desired host strain and grow at 33°C with shaking at 125 rpm. If culture becomes too turbid prior to the conjugation, sub culturing may be necessary.

The night before the conjugation, inoculate the donor strain of S17-1 (pXYZ) in 3mL of growth medium containing antibiotic specific to the plasmid vector. We use the S17-1 strain of E coli because it has the genes necessary for the mobilization and transfer of plasmids.

The morning of the conjugation, pre warm 2xTY plates in 37°C incubator (typically use 1.5’’ small round petri dishes). Sub-culture the overnight S17-1 (pXYZ) culture in the fresh medium without drug; Let it grow to log phase (approx. 2 hours). Dilute cells 1:50 into fresh medium (take 40 ul of cell and in 2ml of 2xTY medium). After subculture has reached the log phase, conjugation procedure is ready to begin.

In a sterile microfuge tube mix 1ml of the recipient host strain with 35 ul of donor S17-1(pXYZ) culture and spin for about 0h 0m 30s at max speed. Decant the supernatant.

In a sterile hood, place a 13mm nitrocellulose filter on the surface of the pre warmed 2XTY plate by using sterile tweezers. Resuspend the cells in the remaining medium using a filtered pipette tip and spot the mixture on top of the filter paper. Incubate at37°C for at least 3h 0m 0s (Note time). While these are incubating it is good idea to pre warm the agar plates to be used later.

At the end of the incubation period, take the plate back to the sterile hood and remove filter from the plate piercing with a sterile tooth pick and transfer into the falcon 2059 (15 ml) tube that contains 1mL of MR26 medium. Vortex to dislodge all the cells from the filter paper.

Transfer the resuspended cell mixture into microcentrifuge tube.

Dilute the resuspended cell mixtre to 1:50 (2ul of cell and 98 ul of medium) to the fresh MR26 medium and plate 50µL of ^GYCC agar plate containing medium with antibiotic selection at the desired concentration.

Incubate the plate(s) in a 33°C incubator. After about 3 days colonies should be observable.

Check colonies under microscope to ensure no contamination.

GYCC ^GYCC

A	B
Ingredients	g/L
Yeast extract
Casamino acids	6 g
Concentrated base (see below for preparation)	5 ml

Adjust PH to 7.1 with NaOH Autoclave 30 mins in liquid cycle

2xTY

A	B
Ingredients	g/L
Tryptone	16 g
Yeast extract	10 g
NaCl	5 g

Fill to 1L with ddH2O Autoclave 30 mins in liquid cycle

MR26

(A) Potassium phosphate buffer, 1M _PH = 6.8 adjusted with KOH or H₃PO₄

        K<sub>2</sub>HPO<sub>4</sub>                115g/L



        KH<sub>2</sub>PO<sub>4</sub>                44.9g/L

(B) Ammonium succinate, 1M P^H= 6.8

      Dissolve 118 g of succinic acid in 500 ml H<sub>2</sub>O. Adjust the P<sup>H</sup> to 6.8 with ammonium hydroxide (It will take                          quite a bit) and add H<sub>2</sub>O.

(C) Concentrated base: Add the following in order to ~500 ml H₂O, then when everything is dissolved, fill with H₂O to 1L. P^H = 6.8 adjusted with NH₄OH.

        EDTA-Na<sub>2</sub>(dihydrate)              11.16 g



        (NH<sub>4</sub>)<sub>6</sub>Mo<sub>7</sub>O<sub>24</sub>.4H<sub>2</sub>O              0.0093 g



        FeSO<sub>4</sub>.7H<sub>2</sub>O                              0.099 g



        “Metals 44”                                50 ml

         MgSO<sub>4</sub>                                       14.5 g



         CaCl<sub>2</sub>                                          2.5 g

Use 20 ml of A, B and C per L of MR26 medium.

*Vitamin stock solution is usually made up separately.

Vitamin solution for 50 ml

        *nicotinic acid                            0.075 g

          Nicotinamide                            0.075 g

        *Thiamine0.                                150 g

           Biotin                                         0.003 g

           Filter sterilize

Metals 44 – per L of stock solution

FeSO₄.7H₂O 5 g

Na₂-EDTA (Dihydrate) 6.5 g

ZnSO₄ 10.9 g

MnCl2.4H₂O 1.3 g

CuSO₄.5H₂O 0.392 g

CoCl₂.6H₂O 0.2 g

H₃BO₃ 0.114 g

Autoclave 30 min in liquid cycle

Add vitamins with antibiotic when needed