Sample preparation for aCGH karyotyping

Hanqin Li, Dirk Hockemeyer

Published: 2022-09-06 DOI: 10.17504/protocols.io.kxygxzdrov8j/v1

Abstract

This protocol describes the standard procedure preparing cell pellets from human pluripotent stem cells (hPSCs) cultured on MEFs for outsourced aCGH karyotyping.

General Notes:

  1. Throughout these protocols, the term hPSC is used to collectively refer to both hiPSCs and hESCs. All described procedures have been tested and work equally well for hiPSCs and hESCs.

Steps

Collecting hPSCs colonies from MEFs

1.

Use one, almost confluent, 6-well plate of hPSCs to prepare cell pellet

2.

Wash once with DPBS

3.

Add 1 ml of 1 mg/ml collagenase solution into each well to separate hPSC colonies from MEFs. Incubate 0h 30m 0s at 37°C.

3.1.

Collagenase solution

AB
Collagenase type IV10 mg
KSR medium10 ml

1 mg/mlFinal volume: 10 ml

KSR medium

AB
DMEM/F12385 ml
Knockout Serum Replacement100 ml
L-Glutamine (200 mM)5 ml
Penicillin & Streptomycin (100X)5 ml
MEM Non-Essential Amino Acids (100X)5 ml

Final volume: 500 ml

4.

Add 2 ml Wash Medium to each well

4.1.

Wash Medium

AB
DMEM/F12470 ml
Newborn Calf Serum25 ml
Penicillin & Streptomycin (100X)5 ml

Final volume: 500 mL

5.

Pipette repeatedly with 5 ml pipette to lift colonies. Be careful not to carry over too many MEFs

6.

Transfer all colonies into a 15 ml tube

7.

Add 7 ml Wash Medium into the 15 ml tube. Pipette with 10 ml Stripette for 5 times to separate MEFs that are attached to hPSCs colonies

8.

Place the 15 ml tubes on a tube rack and gravity settle colonies at Room temperature for 0h 5m 0s.

9.

Aspirate supernatant and add 10 ml Wash Medium. Invert the tube 3 times to mix.

10.

Gravity settle at Room temperature for 0h 5m 0s.

11.

Aspirate supernatant and re-suspend colonies in 10 ml Wash Medium

12.

Place a 40 µm cell strainer onto a 50 ml tube

13.

Strain the colony suspension from step 11. Keep the strainer since colonies are trapped on it.

14.

Wash the strainer with 10 ml Wash Medium (x2)

15.

Revert the strainer and place it in a 6-well plate, bottom-up

16.

Apply 5 ml Wash Medium to the bottom of the strainer, twice. This will separate colonies from the strainer and wash them into the 6-well plate.

17.

Collect colonies from the 6-well plate to a new 15 ml tube

18.

Centrifuge the 15 ml tube at 300x g

19.

Aspirate most of the medium. Leave 1 ml of medium

20.

Re-suspend colonies in the remaining medium, then transfer them to a 1.8 ml Eppendorf tube

21.

Centrifuge the 1.8 ml tube at 300x g

22.

Remove the supernatant and cap the tube

23.

Snap freeze the 1.8 ml tube by placing it in liquid nitrogen for more than 5 min.

24.

Store the snap frozen samples at -80°C, and ship it to Cell Line Genetics on dry ice

推荐阅读

Nature Protocols
Protocols IO
Current Protocols
扫码咨询